Filter
Top Products
clr call from DTE
x121-address
(no idle circuits)
Meaning: The incoming call from DTE address x121-address has been cleared
because an idle circuit is not available to receive the incoming call.
clr:
cct
.
ip_addr.#
(C=
nn
) (D=
nn
)
Meaning: An established DDN or PDN call to the remote host or gateway
identified by ip_addr has been cleared. cct identifies the X.25 DDN or
PDN circuit and # identifies the logical connection number. (C=nn)
contains the decimal contents of the Cause field (octet 4) of the
supervisory header of the packet that CLEARed the call. (D=nn)
contains the decimal contents of the Diagnostic Code field (octet 5) of
the same packet. The tables at the end of this chapter provide a
summary listing of these decimal values.
disable ignored for
virtual-cct
, still processing a previous request
Meaning: NCL’s Disable command was issued for the busy virtual circuit,
virtual-cct.
disable in progress for
virtual-cct
Meaning: Virtual circuit virtual-cct is being disabled.
enable ignored for
virtual-cct
, still processing a previous request
Meaning: NCL’s Enable command was issued for an already enabled (and busy)
virtual circuit, virtual-cct.
enable in progress for
virtual-cct
Meaning: Virtual circuit virtual-cct is being enabled.
fail:
cct
.
ip-address
(C=
mm
) (D=
nn
)
Meaning: A call to the destination with IP address ip-address on the circuit cct has
failed. C (mm) contains the decimal contents of the Cause field (octet
4) of the supervisory header of the packet that failed. D (nn) contains
the decimal contents of the Diagnostic Code field (octet 5) of the same
Event Log Messages
X.25 Event Messages
17-138