Filter
Top Products
CONFIG transfer aborted, no ID string found
Meaning: The router rejected the reception of a new configuration file because it
lacked the proper configuration ID at the beginning of the file. This error
only can occur with the Zget command.
Action: Try again with the proper configuration file.
Data subpacket too long from remote
Meaning: Indicates that the packet received by the router was longer than
expected. Either the packet was corrupted during transmission or the
host was running another protocol.
Action: Check the serial line for a poor connection or source of noise. Also
verify that the host is running Zmodem.
Received a bad 16 bit CRC on a data packet
Received a bad 32 bit CRC on a data packet.
Meaning: Indicate that a data packet received by the router had a bad CRC. (That
is, the packet was damaged in transit.)
Action: Check the serial line for a poor connection or source of noise.
Received a bad 16 bit CRC on binary header
Received a bad 32 bit CRC on binary header
Meaning: Indicate that a binary header received by the router had a bad CRC.
(That is, the packet was damaged in transit.)
Action: Check the serial line for a poor connection or source of noise.
Received a bad 16 bit CRC on hex header
Meaning: Indicates that a hex header received by the router had a bad CRC. (That
is, the packet was damaged in transit.)
Note: There is no 32-bit CRC defined for hex headers.
Action: Check the serial line for a poor connection or source of noise.
Event Log
Messages
17
Event Log Messages
zmodem: Zmodem Event Messages
17-151