Filter
Top Products
Controlling IP-Mapped Circuits for
V. 2 5 b i s
Mapped data is IP data from an IP switched virtual circuit, which is
configured by defining an IP static route and a phone number to IP to
V.25 bis map entry. Individual map entries can be disabled while leaving
others enabled. Three NCL commands are provided for disabling,
enabling, and checking the status of virtual IP maps.
The commands available in this category are the following.
Command Function
Disipmap Disable an IP map. (page 16-88).
Enipmap Enable an IP map that was disabled earlier by Disipmap. (page 16-89).
Ipmap Show the current state of an IP map. (page 16-90).
These commands are described below.
Using the Network Control Language
Controlling IP-Mapped Circuits for V.25 bis
16-86