Filter
Top Products
Enter the DECnet ID of the highest destination area in the range if you are filtering
a range of DECnet destination areas.
Leave this field blank and enter the name of the Area list in the Dest Area (low)
field if you want to use an Area list to establish the upper and lower range of
DECnet destination areas.
For additional information, refer to “Dest Area (low)” later in this chapter. For more
information about Area lists, refer to “Area (high)” and “Area (low)” earlier in this
chapter.
Dest Area (low)
Sets the lower boundary of the range for filtering a DECnet packet based on the
contents of its destination area field.
Options
Leave this field blank if you do not want to filter DECnet destination areas.
Enter the DECnet ID of the destination area in this field and leave the Dest Area
(high) field blank if you are filtering a single DECnet destination area.
Enter the DECnet ID of the lowest destination area in this field and enter the
DECnet ID of the highest destination area in the Dest Area (high) field if you are
filtering a range of DECnet destination areas.
Enter the Area list name in this field and leave the Dest Area (high) field blank if
you want to use an Area list to establish the upper and lower range of DECnet
destination areas,
For more information, refer to “Dest Area (high)” earlier in this chapter. For more
information about Area lists, refer to “Area (high)” and “Area (low)” earlier in this
chapter.
Dest Node (high)
Sets the upper boundary of the range for filtering a DECnet packet based on the
contents of its destination node field.
Options
Leave this field blank if you do not want to filter DECnet destination nodes.
Leave this field blank and enter the DECnet ID of the destination node in the Dest
Node (low) field if you are filtering a single DECnet destination node.
Enter the DECnet ID of the highest destination node in the range if you are
filtering a range of DECnet destination nodes.
Leave this field blank and enter the name of the Node list in the Dest Node (low)
field if you want to use a Node list to establish the upper and lower range of
DECnet destination nodes,
DECnet
Parameters
8
DECnet Parameters
Parameters and Options
8-7