Filter
Top Products
When the global Auto Enable parameter is set to No, the bridge (as are all
other application software modules) is unconditionally disabled. The bridge-
specific Auto Enable parameter is disabled when the global Auto Enable
parameter is disabled.
When the global Auto Enable parameter is set to Yes, the bridge (as are all
other application software modules) is conditionally enabled. The bridge-
specific Auto Enable parameter can be set to enable or disable the bridge.
Default: Yes
No
Disables the bridge-specific Auto Enable parameter if the global Auto Enable
parameter is enabled. If you choose No, you will subsequently need to enable the
bridge manually with the NCL Interpreter after the node boots.
Yes
Enables the bridge-specific Auto Enable parameter if the global Auto Enable
parameter is also enabled.
Note: Select an applicable value for the bridge-specific Auto Enable parameter
regardless of the global Auto Enable parameter setting. If the global Auto Enable
parameter is later enabled, the option selected for the bridge-specific Auto
Enable parameter takes effect.
Block STE
Determines whether the bridge should drop single-route explorer frames
received on the circuit group. Note that this option does not stop single route
explorer frames from being transmitted on the circuit group.
Default: No
No
Disables Block STE.
Yes
Enables Block STE.
Bridge ID (Hex)
Enables source routing. In the initial Bridge screen, identifies a specific source
route bridge. If your network does not include parallel source-routing bridges,
this is the only instance you should enter. But if your network includes parallel
source routing bridges, then you will need to configure a second Bridge ID (Hex)
entry under the ‘‘Source Route Bridge IDs’’ menu item. (The second entry
specifies a second HP bridge configured in parallel with the bridge you are
currently configuring as a source routing bridge.) Both instances of this
parameter use a value between 1 and F (hexadecimal). Leave this field blank if
you do not want to enable source routing.
Default: 1
Disable: Leave Blank
Range: 1 to F (hexadecimal)
Bridge Parameters
Parameters and Options
6-6