Filter
Top Products
config needs phone # to connect
Meaning: The V.25 bis circuit has been configured to be enabled when the circuit
first comes up. However no outbound phone number has been
configured. Therefore this circuit will only be able to connect when a
call comes in.
Action: No user action is required unless you did not intend to configure the
circuit this way.
Connection established
Meaning: The connection with the remote side has been established.
Connection establishment timeout
Meaning: An outbound connection attempt has failed and used up its retry count,
or an inbound connection has timed out. The circuit will be brought
down. New inbound connections will be allowed. However, oubound
connections will not be allowed until the retry delay time has expired.
Action: Increase the retry count and/or connection time as necessary. Also
check other event messages to see if other events occured that caused
the failure.
Connection inactivity timeout
Meaning: A live connection has timed out due to inactivity. The connection will be
closed and reopened when data is available or when an incoming call
arrives.
Action: No action required unless you want the connection to remain active
longer. If so, then increase the inactivity time or change the connection
to enable on cct up.
Connection retry in progress
Meaning: An outbound connection attempt has failed for reasons other than a
timeout. The retry count has not expired for the outbound connection,
so the router will try again.
Event Log Messages
cct: Circuit Event Messages
17-24