Filter
Top Products
Action: Modify the configuration so that the polling interval is within the proper
range.
Bad interface discriminator found
<xxx
>
Meaning: For the indicated frame relay circuit, a packet was received on the
management interface Data Link Connection Identifier (DLCI), but the
protocol discriminator field did not contain the proper value for the
selected management interface method. Proper values are 9 for LMI and
8 for ANSI Annex D. <xxx> identifies the protocol discriminator that
was found.
Bad poll interval; reset to 10
Meaning: For the indicated frame relay circuit, indicates that the polling interval
chosen during configuration is not within the valid range of 5 to 30
seconds.
Action: Modify the frame relay configuration so that the polling interval is within
the proper range.
BNCP is down
Meaning: For the indicated PPP circuit, Bridge Network Control Protocol (BNCP)
has gone down.
BNCP is up
Meaning: For the indicated PPP circuit, Bridge Network Control Protocol (BNCP)
is up. Bridge packets may now be sent and received on the link.
Bridge mapping table is full
Meaning: For the indicated frame relay circuit, the bridge table mapping
destination station addresses to frame relay DLCIs is full and can not
accommodate a new entry. This table is related to the internal bridging
tables and therefore, may be indicative of a bridging problem.
Event Log
Messages
17
Event Log Messages
cct: Circuit Event Messages
17-21