HP (Hewlett-Packard) 200 Network Router User Manual


 
lack_resc_error_rx contains the number of instances that circuit
cct lost a frame because it could not obtain a receive buffer.
latency_tx contains the number of packets (of all priorities) dropped
due to exceeding the maximum link latency configured by the user.
Link_SetUps contains the number of times the link has been set up.
Link_UpTime contains how long the link has been up since the router
has been booted.
lowpri_congestion contains the number of low priority packets
dropped due to congestion.
lowpri_tx contains the number of low priority packets transmitted
without error.
mac_addr contains the 12-digit hexadecimal representation of the
48-bit station address used by circuit cct.
merr contains the number of memory errors. A memory error
indicates that the link level controller, after becoming bus master, failed
to receive a ready signal within 256 increments of the system clock after
asserting a memory address on the data/address bus. A memory error
disables the link level controller.
normpri_congestion contains the number of normal priority
packets dropped due to congestion.
normpri_tx contains the number of normal priority packets
transmitted without error.
octets_rx_ok contains the number of octets (bytes) received
without error by circuit cct.
octets_rx_per_sec contains the number of octets that this circuit has
received in the last second.
octets_tx_ok contains the number of octets (bytes) transmitted
without error by circuit cct.
Management Information Base Variables
cct: Circuits Information Base
18-16