Filter
Top Products
QOS = quality of service
, addr =
DCE
/BIDTE, compression =
Yes
/
No
Meaning: Follows the “circuit in auto-detect mode” message and indicates the
current Quality of Service, Point-to-Point Address, and Compression
parameter settings.
Received a connect delay indication (DLC)
Meaning: The terminal terminal adapter issued a delay call to the router. The
router will retry the call after the delay time requested.
Received a connect indication (CNX)
Meaning: The router has received a connect indication. (This terminal adapter
response is not needed by the router because it uses DSR to indicate
when a call has been established.)
Received a connect fail indication (CFI)
Meaning: The router has received a Call Failure indication from the terminal
adapter. Depending on the configuration, the router will attempt the
connection again automatically.
Action: Check for any logged adapter errors to find out why the call failed, and
correct errors as necessary.
Received call
Meaning: The router has received an incoming call.
Received call dropped (number not allowed)
Meaning: The router received an incoming call, but dropped it because the
number did not match any allowed incoming number.
Action: No user action required. However, if for the call to be accepted, it must
be added to the list of allowed numbers in the configuration file, or the
configuration must be changed to allow all incoming calls.
Event Log
Messages
17
Event Log Messages
cct: Circuit Event Messages
17-43