Filter
Top Products
Managing the Open Shortest Path
First Protocol
OSPF, an IP internal gateway routing protocol, has an openly available
protocol specification that is not proprietary to any single vendor. You
can display the status of various OSPF elements on this router using the
NCL commands listed below. You must use a complete MIB pathname
with each of these commands.
The commands available in this category are the following:
Command Function
Ospf Errs Display OSPF error counts (page 16-73).
Ospf Intf Display the status of the OSPF interfaces (page 16-74).
Ospf Lsdb Display the OSPF link state database (page 16-76).
Ospf Nbrs Display the status of the OSPF neighbors (page 16-78).
Ospf Rtab Display IP’s OSPF routing table (page 16-80).
Ospf Tq Display the OSPF timer queue (page 16-82).
These commands display their output on the console screen. To output
the display to a printer or file instead of the console screen, place the
command syntax, as shown below for each command, within the Print
command (described in an earlier section of this chapter).
NCL
Commands
16
Using the Network Control Language
Managing the Open Shortest Path First Protocol
16-71