Filter
Top Products
Enter the DECnet ID of the source area in this field and leave the Source Area
(high) field blank if you are filtering a single DECnet source area.
Enter the DECnet ID of the lowest source area in this field and enter the DECnet
ID of the highest source area in the Source Area (high) field if you are filtering a
range of DECnet source areas.
Enter the Area list name in this field and leave the Source Area (high) field blank if
you want to use an Area list to establish the upper and lower range of DECnet
source areas.
For more information, refer to “Source Area (high)” earlier in this chapter. For more
information about Area lists, refer to “Area (high)” and “Area (low)” earlier in this
chapter.
Source Node (high)
Sets the upper boundary of the range for filtering a DECnet packet based on the
contents of its source node field.
Options
Leave this field blank if you do not want to filter DECnet source nodes.
Leave this field blank and enter the node number of the source area in the Source
Node (low) field if you are filtering a single DECnet source node.
Enter the node number of the highest source node in the range if you are filtering
a range of DECnet source areas.
Leave this field blank and enter the name of the Area list in the Source Node (low)
field if you want to use an Area list to establish the upper and lower range of
DECnet source nodes.
For additional information, refer to “Source Node (low)” later in this chapter. For
more information about Area lists, refer to “Area (high)” and “Area (low)” earlier in
this chapter.
Source Node (low)
Sets the lower boundary of the range for filtering a DECnet packet based on the
contents of its source node field.
Options
Leave this field blank if you do not want to filter DECnet source nodes.
Enter the node number of the source node in this field and leave the Source Node
(high) field blank if you are filtering a single DECnet source node.
Enter the node number of the lowest source node in this field and enter the node
number of the highest source node in the Source Node (high) field if you are
filtering a range of DECnet source nodes.
DECnet
Parameters
8
DECnet Parameters
Parameters and Options
8-13