Filter
Top Products
Action: Reconfigure the circuit.
CGM misconfigured
Meaning: DLS was unable to notify the upper layer protocols that the circuit has
come up. The Circuit Group Manager module is not active.
Action: Disable the circuit and re-enable it via NCL. If the symptom persists, call
your HP support representative.
Clock recovered
Meaning: The router has detected that data has been transmitted on the WAN
circuit that had previously lost its clock signal. Service has been
restored.
Establishing LLC2 connection
Meaning: Indicates the progress of a circuit configured for LLC2 quality of service;
the router is trying to establish the LLC2 connection with a peer over the
WAN circuit.
Circuit auto-configuring
Meaning: This circuit was configured to auto-detect WAN parameters like Quality
of Service, HDLC addresses, and compression; the router is attempting
to negotiate these parameters.
Detected carrier, enabling cct
Meaning: The router has detected the carrier signal on the WAN circuit; the circuit
will become operational.
Invalid Configuration: QOS must be LLC2
Meaning: Auto-configuring has detected a remote bridge, but the router’s
QOS configuration option is not set to LLC2 or auto-configure.
Action: Use the LLC2 or auto-configure option to configure the QOS for the
Point-to-Point WAN circuit.
Event Log Messages
dls: Data Link Services Event Messages
17-70