Filter
Top Products
Intel® PXA255 Processor Developer’s Manual 16-19
Network SSP Serial Port
Table 16-3. SSCR0 Bit Definitions (Sheet 1 of 2)
0x4140_0000 SSCR0 Network SSP Serial Port
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
reserved
EDSS
SCR
SSE
reserved
FRF
DSS
? ? ? ? ? ? ? ? ? ? ? 0 0 0 0 0 0 0 0 0 0 0 0 0 0 ? 0 0 0 0 0 0
Bits Name Description
31:21 — reserved
20 EDSS
EXTENDED DATA SIZE SELECT:
Used in conjunction with DSS to select the size of the data transmitted and received by the SSP.
0 – Pre-appended to the DSS value. Sets the DSS range from 4-16- bits.
1 – Pre-appended to the DSS value. Sets the DSS range from 17-32-bits.
19:8 SCR
THE SERIAL CLOCK RATE:
Selects the bit rate of the SSP when in master mode with respect to the SSPSCLK (as defined
by SSCR1[SCLKDIR]). The maximum bit rate is 3.6864 Mbps. The clock is divided by the value
of SCR plus 1 (a range of 1 to 4096) to generate the serial clock (SSPSCLK).
This field is ignored when the SSP is a slave with respect to SSPSCLK (defined by
SSCR1[SCLKDIR]) and transmission data rates are determined by the external device
(Maximum of 13 MHz). At these fast baud rates, using polled/interrupt mode is insufficient to
keep the FIFO filled. You must use DMA mode.
NOTE: Software must not change SCR when the SSPSCLK is enabled because doing so
causes the SSPSCLK frequency to immediately change.
Serial bit rate = SSP Clock / (SCR + 1)
7SSE
SYNCHRONOUS SERIAL PORT ENABLE/DISABLE:
Enables and disables all SSP operations. When the port is disabled, all of its clocks can be
stopped by programmers to minimize power consumption.
When cleared during active operation, the SSP is disabled immediately, terminating the current
frame being transmitted or received. Clearing SSE resets the port FIFOs and the status bits;
however, the SSP control registers are not reset.
NOTE: After reset or after clearing the SSE, software must ensure that the SSCR1, SSITR,
SSTO, and SSPSP control registers are properly re-configured and that the SSSR
register is reset before re-enabling the SSP by setting SSE. Also, SSE must be cleared
before re-configuring the SSCR0, SSCR1, or SSPSP registers; any or all control bits in
SSCR0 can be written at the same time as the SSE.
0 – SSP operation disabled
1 – SSP operation enabled
6 — reserved
5:4 FRF
FRAME FORMAT:
SELECTS which frame format to use.
0b00 – Serial Peripheral Interface*
0b01 – TI Synchronous Serial Protocol*
0b10 – Microwire*
0b11 – Programmable Serial Protocol