Filter
Top Products
Modifying a Command
1. To enter the creation/editing mode, press:
2. To select the particular test sequence you wish to modify, (sequence 1 in this example),
press:
~~~~~.:~~~~:~~~~~
. . . . . . . .
i
i
i
. . . .
..A.
.v.:.w
The following list is the commands entered in “Creating a Sequence.’ Notice that for longer
sequences, only a portion of the list can appear on the screen at one time.
Start of Sequence
RECALLPRSTSTATE
Trans: FWD
S21
(B/R)
LOG MAG
CENTER
134
M/u
SPAN
50
M/u
SCALE/DIV
AUTO SCALE
3.
To change a command (for example, the span value from 50 MHz to 75 MHz), move the
cursor
(-+) next to the command that you wish to modify, press:
n
If you use the
&)
key to move the cursor through the list of commands, the commands are
actually performed when the cursor points to them. This feature allows the sequence to
be tested one command at a time.
n
If you wish to scroll through the sequence without executing each line as you do so, you
can press the
@J key and scroll through the command list backwards.
4.
lb
delete the current command (for example, span value), press:
El
5.
To
insert a new value (for example, 75 MHz), press:
_
_
.,.
/
.,.
. . . .
6.
fiess
m
~~~~~~~~~~~~~~
to
etit
the
mo&fy
(e&t)
mode.
.. .._.....
..........,.:::...~~~.;;~~
. .
..A
..s.:
. .
..A
. . . . .
..A
..7:,..:
::.
_...
.:...a
. . . . .
.
.w>
.
. . .
.
.A....
.;u;;:.;;;;Av~~~~:
Clearing a Sequence from Memory
1. To enter the menu where you can clear a sequence from memory, press:
2. To clear a sequence, press the
softkey of the particular sequence.
2.72 Making Measurements