Filter
Top Products
selects channel 4 memory trace for display color modification.
selects channel 4 memory trace for display color
.,.,.,.,
. . . . .
1
.z
“i..m:;
;w;j:
_
;~
mo&fication.\
~~~~~~~~:lt~\brings
up
the
printer
color
..:..:
..i
.:::
.
.
.
. .
.
.
.
.
.
.
.
.
.
.
.
. .
..i..~.........~~~.~~~...
. . . . . . . . . .
.
.
.
. .
.
.
.
.
.
.
.
.
.
.
.
. .
.
.
.
selection menu. The channel 2 data trace default color is blue
for color prints.
is used to apply the same power levels to each channel.
is used to apply different power levels to each channel.
configures
multiple-channel displays so that the auxiliary
channels are adjacent to or beneath the primary channels.
measures A and B inputs simultaneously for faster
measurements.
when the parallel port is configured for GPIO, 8 output bits can
be controlled with this key. When this key is pressed,
“TTL
OUT BIT NUMBER” becomes the active function. This active
function must be entered through the keypad number keys,
followed by the
Lxl]
key. The bit is cleared when the
Ixl)
key
is pressed. Entering numbers larger than 7 will result in bit 7
being cleared, and entering numbers lower than 0 will result in
bit 0 being cleared.
deletes
ail
segments in the list.
clears a sequence from memory. The titles of cleared sequences
will remain in load, store, and purge menus. This is done as a
convenience for those who often reuse the same titles,
dehnes the standard (and the offset) as coaxial. This causes the
analyzer to assume linear phase response in any offsets.
applies a linear phase compensation to the trace for use
with electrical delay. That is, the effect is the same as if a
corresponding length of perfect vacuum dielectric coaxial
transmission line was added to the reference signal path.
provides access to the configure menu. This menu contains
softkeys used to control raw offsets, spur avoidance, and the
test set transfer switch.
adjusts the degree of whiteness of the color being modified. See
“Adjusting Color” for an explanation of using this
softkey
for
color modification of display attributes.
provides access to the configure ext disk menu. This menu
contains softkeys used to the disk address, unit number, and
volume number.
located under the
[s)
key, selects the
configure
menu.
resumes a paused sequence.
Key Definitions
9-9