Filter
Top Products
......................
....
.................
:
...
gggs&fi
i..
..........
.:.
....I..
.. .:.<
............................
.._...._ ........
-.
g{~$;~~f
~~~~
.._...........
lets you enter a label for the reverse transmission class. The
label appears during a calibration that uses this class.
specifies which standards are in the reverse transmission class
in the calibration kit.
is used to enter the standard numbers for the reverse
transmission (thru) calibration. (For default kits, this is the
alru.)
adjusts the source frequency higher than the LO by the amount
of the LO (within the limits of the analyzer).
adjusts the source frequency lower than the LO by the amount
of the LO (within the limits of the analyzer).
draws a quarter-page plot in the lower right quadrant of the
Page.
draws a quarter-page plot in the upper right quadrant of the
page.
resets the seconds counter to zero in real-time clock.
presents the S-parameter menu, which is used to define
the input ports and test set direction for S-parameter
measurements
provides a measurement calibration for reflection-only
measurements of one-port devices or properly terminated
two-port devices, at port 1 of an S-parameter test set or the test
port of a transmission/reflection test set.
is used to enter the standard numbers for the
Rrst
class
required for an
SII
l-port calibration. (For default cal kits, this
is the open.)
is used to enter the standard numbers for the second class
required for an
S11
l-port calibration. (For default
cal
kits, this
is the short.)
is used to enter the standard numbers for the third class
required for an
SKI
l-port calibration. (For default kits, this is
the load.)
measures the short circuit
TRLLRM
calibration data for
PORT 1.
provides a measurement calibration for reflection-only
measurements of one-port devices or properly terminated
two-port devices, at port 2 of an S-parameter test set or the test
port of a transmission/reflection test set.
is used to enter the standard numbers for the hrst class
required for an
SZ2
l-port calibration. (For default
cal
kits, this
is the open.)
is used to enter the standard numbers for the second class
required for an
f&z.
l-port calibration. (For default cal kits, this
is the short.)
Key Definitions 8-39