(Option 010 only) is used to specify the parameters of the
window in the transform menu.
(Option 010 only) sets the pulse width to the widest value
allowed.
This
minimizes the sidelobes and provides the greatest
dynamic range.
(Option 010
only)
is used to set the window of a time domain
measurement to the
minimum value. Provides essentially no
window.
(Option 010
only)
is used to set the window of a time domain
measurement to the normal value.
Usually
the most useful
because it reduces the sidelobes of the measurement somewhat.
is used to terminate basic units:
dB,
dBm,
Hz,
dE?/GHz,
degrees,
or seconds. It may
also
be used to terminate
unitless
entries
such as averaging factor.
toggles the
PLOTTER/PRINTER
serial port data transmit
control mode between the Xon-Xoff protocol handshake and
the DTR-DSR (data terminal ready-data set ready)
hardwire
handshake.
converts reflection data to its equivalent admittance values
converts transmission data to its equivalent admittance values.
converts reflection data to its equivalent impedance values.
converts transmission data to its equivalent impedance
values.
Key Definitions
6-63