Filter
Top Products
softkey
labels,
l-10
softkeys, 14
stimulus function block,
l-4
test sequence connector, 1-12
test set interconnect, 1-12
logarithmic frequency sweep, 6-23
log magnitude format, 6-32
LOG MKR, 2-25, 2-26
loop counter sequence, 2-77
loss of power meter calibration data, 5-34
Lo
to RF isolation for mixers, 3-33
low pass mode
reflection measurements, 6-131
setting frequency range, 6-130
transmission measurements, 6-133
M
magnitude
specifications, 7-13
magnitude and insertion phase response
measurement, 2-37
making accurate measurements
electrically long devices, 548
making measurements,
2-l
man status notation,
l-9
marker
control, 2-18
values area on display,
l-10
(&iZZZT]
menu map,
818
e
menu map, 8-8
markers
activating, 2-18
active and inactive, 2-18
calculate data statistics, 2-36
continuous and discrete, 2-17
couple and uncouple display markers, 2-24
coupled, 6-9
delta mode, 6-55
delta (A), 2-20
fixed,
2-21
fixed
reference, 6-55
functions, 6-56
functions on display, 2-17
G+jB MKR, 2-26
LIN MKR, 2-25, 2-26
LOG
MKR,
2-25, 2-26
menu, 6-55
modes, 6-56
moving off of grids, 2-19
polar format, 2-24, 6-56
reference, 2-20
Re/Im
MRR,
2-25, 2-26
relative mode, 2-20
R+jX MKR, 2-26
search for bandwidth, 2-35
search for maximum amplitude, 2-32
search for
minimum amplitude, 2-33
search for target amplitude, 2-34
searching, 2-32
search mode, 6-56
set CW frequency, 2-31
set display reference, 2-30
set electrical delay, 2-31
set frequency span, 2-29
set measurement parameters, 2-26
setting center frequency, 2-28
setting start frequency, 2-27
setting stop frequency, 2-27
smith chart, 6-56
Smith chart markers, 2-25
Smith or polar format, 2-22
target mode, 6-56
tracking amplitude, 2-35
using, 6-54-56
zero, 2-23
marker stats
bandwidth on display, l-10
masking
time domain, 6-135
mass storage, 11-5
matched adapters
using to calibrate noninsertable devices,
5-47, 6-109
math with data traces, 2-8
maximum amplitude search, 2-32
LMeas]
key, 6-29, 6-30
LMeas)
menu map, 8-9
measure
deviation from linear phase, 242
device under test, 2-5
electrical length and phase distortion, 2-40
gain and reverse isolation, 2-59
gain compression, 2-55
group delay, 2-43
increased accuracy, 5-2
magnitude and insertion phase response,
2-37
swept harmonics, 2-81
transmission response in time domain,
2-83
using
Iimit
lines, 2-46
using swept list mode, 2-61
using the time domain, 2-83
measured inputs of display,
l-9
measurement
channel viewing, 2-6
conversion loss example, 3-11
data
pointxsetting,
2-4
data statistics, 2-36
error-correction, 5-4
Index-13