HP (Hewlett-Packard) HP 8753E Network Cables User Manual


 
Controller
An external controller is not required for measurement calibration or time domain capability.
However, some performance test procedures are semi-automated and require the use of an
external controller. (The system verification procedure does not require an external controller.)
The system can be automated with the following computers:
m
IBM PC compatible computer with an HP-IB/GP-IB interface card
n
HP 9000 series
200/300
workstation
l
HP 9000 series 700 workstation with HP BASIC-UX
For more information about compatible computers, call your nearest Hewlett-Packard Sales and
Service office.
Sample Software
A set of sample measurement programs is provided with the
HP
8753E
Network
Atruzlgm
prOgmmmer’s
Guid.e
on a 3.5 inch disk. The programs include typical measurements to be
used as an introductory example for progr
amming
the analyzer over HP-IB. It is designed to be
easily modified for use in developing programs for specific needs. The programs are compatible
with HP BASIC versions 2.0 and later,
QuickBASIC,
and
QuickC,
and will run on an IBM PC
compatible computer (as well as the HP 9000 series
200/300/700
workstations), using any
HP 87533 compatible printer or plotter.
The following additional software products are
also
available for the HP 8753E:
n
HP 85190A IC-CAP Modeling Suite
n
Touchstone
n
(MDS) HP Microwave Design System
n
EEsof
Series-IV
External Monitors
The analyzer can drive both its internal display and an external monitor simultaneously.
I&commended Color Monitors:
n
HP
D2804A,
Super VGA 1024 (14 inch display)
n
HP
D2806B,
Ergo Ultra VGA (15 inch display)
n
HP
D2817A,
Ultra VGA 1280 (17 inch display)
External Monitor Requirements:
VGA Compatible
q
640 (horizontal) x 480 (vertical) resolution
q
59.83 Hz vertical refresh rate
q
16.716
mS
vertical time
q
31.41
kHz
horizontal refresh rate
q
31.840
&S
horizontal time
q
75 ohm video input impedance
q
video analog amplitude 0.7 Vp-p
q
negative true
TI’L
logic for vertical and horizontal synchronization
Compatible Peripherals 11-7