Filter
Top Products
POWERSUPPLYSHUTDOWN!
Error Number One or more supplies on the
A8
post-regulator assembly have been shut down
22
due to an over-current, over-voltage, or under-voltage condition.
POWERUNLEVELED
Error Number There is either a hardware failure in the source or you have attempted to set
179
the power level too high. The analyzer allows the output power to be set
higher or lower than the specified available power range. However, these
output powers may be unleveled or unavailable. Check to see if the power
level you set is within specifications If it is, refer to the
HP 8753E Network
Anulym
Semvice
ouide
for troubleshooting.
PRESS
[MENUI,
SELECTCW
(IF)
FREQ,THENSWEPTLO
Error Number When you are sweeping the RF and LO, the IF must be
fixed.
161
PRINTABORTED
Error Number When you press the
m
key, the analyzer aborts output to the printer.
25
printcolornot
supporteduithEPSON
Error Number You have
defined
the printer type as
EPSON-P2.
Color print is not supported
178
with this printer. The print will abort.
PRINTER:busy
Error Number The parallel port printer is not accepting data.
176
PRINTER:
error
Error Number The parallel port printer is malfunctioning. The analyzer cannot complete the
175
copy function.
1 O-20
Error Messages