Filter
Top Products
IFBWKEYDISABLED,
EDITLISTMODETBL
Information
When list IF bandwidth has been enabled and swept list mode
is
on,
you
will
Message
not be able to change the IF bandwidth using the
&E?#&
key. To change the
IF
..-.....
bandwidth, edit the swept list table.
ILLEGALUNITORVOLUMENUMBER
Error Number The disk unit or volume number set in the analyzer is not
valid.
Refer to the
46
disk drive operating manual.
INITDISKremoves
alldatafromdisk
Information
Continuing with the initialize operation will
destro@
any data currently on the
Message
disk.
INITIALIZATIONFAILED
Error Number The disk initialization failed, probably because the disk is damaged.
47
INSTRUMENTSTATEMEMORYCLEARED
Error Number All instrument state registers have been cleared from memory along with any
56
saved calibration data, memory traces, and calibration kit
definitions.
Additionally, all user-settable selections (such as HP-IB addresses) are set to
their defaults.
INSUFFICIENTMEHORY
Error Number Your last front panel or HP-IB request could not be implemented due to
51
insufficient memory space. In some cases, this is a fatal error from which you
can escape only by presetting the instrument.
INSUFFICIENTMEMORYFORPRINT/PLOT
Error Number There is not enough memory available for the print or plot function. Increase
168
the available memory by changing or eliminating a memory-intensive operation
such as reducing the number of points in the sweep.
Error
Mesqes
lo-13