Filter
Top Products
Analyzer Options Available
Option
lD6,
High Stability Frequency Reference
Option lD5 offers
kO.05
ppm temperature stability from 0 to 60
OC
(referenced to 25
“C).
Option 002, Harmonic Mode
Provides measurement of second or third harmonics of the test device’s fundamental output
signal. Frequency and power sweep are supported in this mode. Harmonic frequencies can be
measured up to the maximum frequency of the receiver. However, the fundamental frequency
may not be lower than 16
MHz.
Option 006, 6
GHz
Operation
Option 006 extends the maximum source and receiver frequency of the analyzer to 6
GHz.
Option 010, Time Domain
This option displays the time domain response of a network by computing the inverse Fourier
transform of the frequency domain response. It shows the response of a test device as a
function of time or distance. Displaying the reflection coefficient of a network versus time
determines the magnitude and location of each discontinuity. Displaying the transmission
coefficient of a network versus time determines the characteristics of individual transmission
paths. Time domain operation retains all accuracy inherent with the correction that is active in
the frequency domain. The time domain capability is useful for the design and characterization
of such devices as SAW
iilters,
SAW delay lines, RF cables, and RF antennas.
Option 011, Receiver Configuration
Option 011 allows front panel access to the R, A, and B samplers and receivers. The transfer
switch, couplers, and bias tees have been removed. Therefore, external accessories are
required to make most measurements.
Option
076,
768
Impedance
Option 075
offers 75 ohm impedance bridges with type-N test port connectors.
Option
lDT,
Delete Display
This option removes the built-in flat panel display, allowing measurement results to be viewed
with an external monitor only.
Option
lCM,
Rack Mount Flange Kit Without Handles
Option
1CM
is a rack mount kit containing a pair of flanges and the necessary hardware to
mount the instrument, with handles detached, in an equipment rack with 482.6 mm (19 inches)
horizontal spacing.
HP 8753E Description and Options
1-13