Filter
Top Products
STATus Subsystem
2–158
TVS600 & TVS600A Command Reference
when measurement or acquisition starts. All other positive Operation
events are disabled.
Query: STAT:OPER:PTR?
Response: 16
STATus:OPERation?
STATus:OPERation:CONDition?
STATus:OPERation:NTRansition
STATus:PRESet
STATus:OPERation:QENable:NTRansition
STATus:OPERation:QENable:NTRansition?
Sets or queries the contents of the Negative Transition Queue Enable Register
(NTQER) for the Operation Status Register. When you set an event bit true (1) in
the NTQER, the corresponding event the Operation Status Condition Register
generates a message in the Status Queue when the event line changes from true
to false (1 to 0)
. The NTQER bits correspond to the Operation Status Register
bits. Refer to Table 2–2 on page 2–152 for a definition of the events associated
with the Operation Status Register bits. The command STATus:OPERa-
tion:QENable:PTRansition provides similar control for positive event transi-
tions. For an overview of the status and event reporting system, refer to the
TVS600 & TVS600A Series Waveform Analyzers User Manual.
STATus:PRESet sets all register bits to zero (0) which disables the reporting of
negative event transitions. Setting unused enable bits does not generate an error,
they are ignored.
STATus:OPERation:QENable:NTRansition <mask>
STATus:OPERation:QENable:NTRansition?
<mask> Query response
<NRf> | <Non-decimal numeric>
0 ≤ N ≤ #HFFFF
<NR1>
Not applicable
Execution Error –222, “Data out of range”
Attempted to set the queue enable register to an illegal value.
Related Commands
Syntax
Parameters
Reset Value
Errors and Events