Filter
Top Products
CALCulate Subsystem
2–32
TVS600 & TVS600A Command Reference
CALCulate:FILTer:FREQuency[:TYPE]
CALCulate:FILTer:FREQuency[:TYPE]?
Sets or queries the type of FREQuency filtering to perform on an acquisition
record.
The available filter types are as follows:
H BPASs—rejects frequency components outside the defined frequency range.
H NOTCh—rejects frequency components within a defined frequency range.
H HPASs—rejects frequency components below a specified frequency.
H LPASs—rejects frequency components above a specified frequency.
When you set :TYPE to bandpass or notch, set the filter parameters with the
:FILTer:FREQuency commands STARt, STOP, CENTer, and SPAN. When you
set :TYPE to high pass or low pass, set the filter parameters with the commands
HPASs or LPASs. For an overview of the measurement system, refer to the
TVS600 & TVS600A User Manual.
CALCulate<n>:FILTer[:GATE]:FREQuency[:TYPE] <type>
CALCulate<n>:FILTer[:GATE]:FREQuency[:TYPE]?
<n>
1
Query response
1
2
3
4
Not applicable
1
The calculate block number <n> selects one of four calculate blocks. If you omit <n>,
the default is calculate block 1.
<type> (Frequency filter) Query response
BPASs
HPASs
LPASs
NOTCh
BPAS
HPAS
LPAS
NOTC
BPAS
Execution Error –141, “Invalid character data”
Attempted to set type to an illegal value.
Syntax
Parameters
Reset Value
Errors and Events