Filter
Top Products
TRIGger[:A] Subsystem
2–234
TVS600 & TVS600A Command Reference
TRIGger:DELay
TRIGger:DELay?
Sets or queries the trigger delay for the Trigger A circuit. Trigger delay sets the
time after the trigger event to start acquisition. TRIGger:DELay is always
positive which delays the start of acquisition a specified time after the trigger
event. Use SWEep:OFFSet:TIME to acquire pretrigger data. The mininum real
delay is 16 ns. Setting TRIGger:DELay to 0 indicates no delay and bypasses the
delay counter.
For further information, refer to the TVS600 & TVS600A Series Waveform
Analyzers User Manual.
TRIGger[:A]:DELay <delay_time>
TRIGger[:A]:DELay?
<delay_time>
1
Query response
<NRf>
16 ns ≤ N ≤ 250 s (in 4 ns steps )
MINimum
MAXimum
<NR3>
0.0E+0
250.0E+0
1
The default for the parameter <delay_time> is seconds (S). You can also use the
multipliers MS for milliseconds, US for microseconds, and NS for nanoseconds.
0.0E+0
Execution Error –222, “Data out of range”
Attempted to set trigger delay to an illegal value.
Setting TRIGger:DELay to a value greater than 0 will cause TRIGger:B:DELay
to be set to 0. Only one trigger delay may be active.
Setting TRIGger:DELay to a value greater than 0 when TRIGger:B:SOURce is
set to INTernal<1234> or EXTernal, will set TRIGger:B:ECOunt to 1.
Command: TRIG:DEL 10E-6
Query: TRIG:DEL?
Response: 10.0E-6
Syntax
Parameters
Reset Value
Errors and Events
Dependencies
Examples