Filter
Top Products
CALCulate Subsystem
TVS600 & TVS600A Command Reference
2–35
CALCulate:FILTer:FREQuency:HPASs
CALCulate:FILTer:FREQuency:HPASs?
Sets or queries the limit frequency (<cutoff>) below which the filter attenuates
all frequency components. The :HPASs frequency is ignored when you select the
bandpass, notch or low-pass filter. Use the command CALCulate:FILTer:FRE-
Quency HPASs to enable the high-pass filter.
CALCulate<n>:FILTer[:GATE]:FREQuency:HPASs <cutoffā>
CALCulate<n>:FILTer[:GATE]:FREQuency:HPASs?
<n>
1
Query response
1
2
3
4
Not applicable
1
The calculate block number <n> selects one of four calculate blocks. If you omit <n>,
the default is calculate block 1.
<cutoff> (Limit frequency)
1
Query response
<NRf> <NR3>
1
The default multiplier for the <cutoff> parameter is HZ for hertz. You can also use the
multipliers KHZ for kilohertz, MHZ for megahertz, and GHZ for gigahertz.
250.0E+6
Execution Error –222, “Data out of range”
Attempted to set the high pass cutoff frequency to an illegal value.
None
Command: CALC1:FILT:FREQ:HPAS 10E6
Query: CALC1:FILT:FREQ:HPAS?
Response: 10.0E+6
CALCulate:FILTer:FREQuency:LPASs
Syntax
Parameters
Reset Value
Errors and Events
Dependencies
Examples
Related Commands