Filter
Top Products
SYSTem Subsystem
TVS600 & TVS600A Command Reference
2–199
Command: SYST:COMM:SER:PRES:TERM
SYSTem:COMMunicate:SERial Commands
SYSTem:COMMunicate:SERial:SBITs
SYSTem:COMMunicate:SERial:SBITs?
Sets or queries the number of stop bits sent with each character transmitted on
the front panel RS-232 port. Both transmit and receive values are set by this
command. Refer to the TVS600 & TVS600A Series Waveform Analyzers User
Manual for the factory setting.
When you set :SERial:SBITs, the new value is stored in nonvolatile RAM and is
recalled at power up. However, the number of stop bits is not saved with stored
settings (*LRN) and it is not reset to a default value by *RST.
SYSTem:COMMunicate:SERial:SBITs <stop_bits>
SYSTem:COMMunicate:SERial:SBITs?
<stop_bits> Query response
<NRf>
1 or MINimum
2 or MAXimum
<NR1>
1
2
Not applicable
Execution Error –222, “Data out of range”
Attempted to set the number of stop bits to an illegal value.
None
Command: SYST:COMM:SER:SBIT 2
Query: SYST:COMM:SER:SBIT?
Response: 2
SYSTem:COMMunicate:SERial:BAUD
SYSTem:COMMunicate:SERial:PARity
Examples
Related Commands
Syntax
Parameters
Reset Value
Errors and Events
Dependencies
Examples
Related Commands