Filter
Top Products
CALCulate Subsystem
2–42
TVS600 & TVS600A Command Reference
CALCulate:FILTer:FREQuency:STOP
CALCulate:FILTer:FREQuency:STOP?
Sets or queries the stop, or upper limit, frequency of the bandpass and notch
filters. :STARt and :STOP define the frequency range for the filters :FREQuen-
cy:BPASs and :FREQuency:NOTCh. The commands :FREQuency:CENTer and
:FREQuency:SPAN provide an alternate way to set the filter range.
The STOP frequency is ignored when filter type is set to high pass or low pass.
CALCulate<n>:FILTer[:GATE]:FREQuency:STOP <stop>
CALCulate<n>:FILTer[:GATE]:FREQuency:STOP?
<n>
1
Query response
1
2
3
4
Not applicable
1
The calculate block number <n> selects one of four calculate blocks. If you omit <n>,
the default is calculate block 1.
<stop> (Ending frequency of range)
1
Query response
<NRf> <NR3>
1
The default multiplier for the parameter <stop> is HZ for hertz. You can also use the
multipliers KHZ for kilohertz, MHZ for megahertz, and GHZ for gigahertz.
300.0E+6
Execution Error –222, “Data out of range”
Attempted to set stop to an illegal value.
You can set the frequency range for the frequency filters :NOTCh and :BPASs
with either the command pair :CENTer and :SPAN or the command pair :STARt
and :STOP. Because both command pairs control the same parameters, changing
either command pair will affect the other.
Command: CALC1:FILT:FREQ:STOP 10.01E6
Query: CALC1:FILT:FREQ:STOP?
Syntax
Parameters
Reset Value
Errors and Events
Dependencies
Examples