Filter
Top Products
CALCulate Subsystem
TVS600 & TVS600A Command Reference
2–33
None
Command: CALC1:FILT:FREQ NOTCH
Query: CALC1:FILT:FREQ?
Response: NOTC
CALCulate:FILTer:FREQuency:CENTer
CALCulate:FILTer:FREQuency:HPASs
CALCulate:FILTer:FREQuency:LPASs
CALCulate:FILTer:FREQuency:SPAN
CALCulate:FILTer:FREQuency:STARt
CALCulate:FILTer:FREQuency:STATe
CALCulate:FILTer:FREQuency:STOP
CALCulate:FILTer:FREQuency:CENTer
CALCulate:FILTer:FREQuency:CENTer?
Sets or queries the center frequency of the bandpass or notch filter. Use the
command :FREQuency:SPAN to set the frequency range for :NOTCh and
BPASs frequency filters. For example, if you set :CENTer to 10 MHz and :SPAN
to 2 MHz, then the :NOTCh filter will have a range of 9 MHz
to 11 MHz. For an overview of the measurement system, refer to the TVS600 &
TVS600A Series Waveform Analyzers User Manual.
CALCulate<n>:FILTer[:GATE]:FREQuency:CENTer <center>
CALCulate<n>:FILTer[:GATE]:FREQuency:CENTer?
<n>
1
Query response
1
2
3
4
Not applicable
1
The calculate block number <n> selects one of four calculate blocks. If you omit <n>,
the default is calculate block 1.
Dependencies
Examples
Related Commands
Syntax
Parameters