Filter
Top Products
CALCulate Subsystem
TVS600 & TVS600A Command Reference
2–39
Execution Error –222, “Data out of range”
Attempted to set rejection to an illegal value.
None
Command: CALC1:FILT:FREQ:SREJ 75
Query: CALC1:FILT:FREQ:SREJ?
Response: 75.0
CALCulate:FILTer:FREQuency:TWIDth
CALCulate:FILTer:FREQuency:STARt
CALCulate:FILTer:FREQuency:STARt?
Sets or queries the start, or lower limit, frequency of the bandpass and notch
filters. :STARt and :STOP define the frequency range for the filters :FREQuen-
cy:BPASs and :FREQuency:NOTCh. The commands :FREQuency:CENTer and
:FREQuency:SPAN provide an alternate way to set the filter range. For an
overview discussion of the waveform analyzer digital filter, refer to the TVS600
& TVS600A Series Waveform Analyzers User Manual.
The :STARt frequency is ignored when you select the high-pass or low-pass
filter.
CALCulate<n>:FILTer[:GATE]:FREQuency:STARt <start>
CALCulate<n>:FILTer[:GATE]:FREQuency:STARt?
<n>
1
Query response
1
2
3
4
Not applicable
1
The calculate block number <n> selects one of four calculate blocks. If you omit <n>,
the default is calculate block 1.
Errors and Events
Dependencies
Examples
Related Commands
Syntax
Parameters