Filter
Top Products
SYSTem Subsystem
TVS600 & TVS600A Command Reference
2–185
See SWEep:TINTerval side effects.
Command: SYST:AUT:SWE CHAN1
SWEep:TINTerval
SYSTem:AUToset:VOLTage
SYSTem:AUToset:TRIGger
SYSTem:AUToset:TRIGger
TVS600A Models Only
This command sets the TRIGger[:A]:SOURe to <channel> and TRIGger:LEVel
to 50% of the peak to peak value of the trigger signal.
A binary search algorithm will be used with the trigger comparator to find the
peaks of the trigger signal. The trigger search will timeout after approximately
20ms. This implies that the incoming signal should be a repetitive 50Hz signal
or faster.
If no triggers are found then the trigger level will be unchanged.
It is the responsibility of the host application to preset all related settings such as
bandwidth filters, couplings, vertical settings, and so on.
After autoset completes, the host application can query TRIGger:LEVel to find
out what was done.
When part of a global autoset, SYSTem:AUToset:VOLTage should be performed
first.
SYSTem:AUToset:TRIGger <channel>
<channel> Query response
CHAN[1]
CHAN2
CHAN3
CHAN4
Not applicable
None
Not applicable
Dependencies
Examples
Related Commands
Syntax
Parameters
Suffix Units and
Multipliers
Reset Value