Filter
Top Products
Memory Expansion Boards
ARM DUI 0224F Copyright © 2003-2007 ARM Limited. All rights reserved. E-13
E.4 Connector pinout
This section describes the connectors present on the expansion memory boards.
E.4.1 Expansion connector
The static and dynamic memory expansion boards use 120-way Samtec connectors as
shown in Figure E-5. The connector pinout for the dynamic memory board is shown in
Table E-5 on page E-14. The connector pinout for the static memory board is shown in
Table E-6 on page E-16.
Note
The numbering of pins on the connectors is for the connectors as viewed from below.
Figure E-5 Samtec connector
Note
Table E-5 on page E-14 and Table E-6 on page E-16 pinout and naming are valid for all
pre-v1.0 PISMO compliant memory expansion boards. For v1.0 onwards please check
the latest PISMO specification at www.pismoworld.org