Filter
Top Products
Configuring the USB Debug Connection
G-10 Copyright © 2003-2007 ARM Limited. All rights reserved. ARM DUI 0224F
G.4 Using the Debug tab of the RealView Debugger Register pane
When you install the RealView ICE Micro Edition software and connect to a
PB926EJ-S, a Debug tab is added to the Register pane of the RealView Debugger Code
window. This controls various internal debugger registers, many of which are specific
to using the USB debug port. To use this tab, you must first connect RealView Debugger
to your PB926EJ-S, as described in Using the USB debug port to connect RealView
Debugger on page G-6. A typical setting window is shown in Figure G-8.
Figure G-8 The Debug tab of the Register pane
There are three groups of settings:
• Global Properties
• Device Properties on page G-12
• Semihosting Properties on page G-13.