Filter
Top Products
Configuring the USB Debug Connection
ARM DUI 0224F Copyright © 2003-2007 ARM Limited. All rights reserved. G-7
4. Click on VPB926EJ-S USB in the Connection Control window. If the debugger
is able to connect to the PB926EJ-S, the Connection Control window displays
the connection to the ARM926EJ-S PXP Development Chip as shown in
Figure G-3.
Figure G-3 ARM926EJ-S PXP Development Chip detected
Note
If the there is not a VPB926EJ-S USB entry in the Connection Control window,
the RVI-ME software is not installed. Close the RealView Debugger and install
the software (see Installing the RealView ICE Micro Edition driver on page G-2).
You might see one of the following errors:
• If the PB926EJ-S is not powered, it displays the error shown in Figure G-4.
If you see this error, ensure that power is supplied.
Figure G-4 Error shown when unpowered devices are detected