Filter
Top Products
Getting Started
2-22 Copyright © 2003-2007 ARM Limited. All rights reserved. ARM DUI 0224F
Caution
Formatting the Disk-on-Chip erases all files present on the NAND flash. The
Disk-on-Chip is formatted at manufacture. Only reformat if the flash has become
corrupted.
8. Load the initial program loader files for the Disk-on-Chip. At the Boot Monitor
prompt enter:
Config> WRITE IPL C:\temp\doc_ipl.axf
After a short delay, a message displays indicating that the loader has been
successfully programmed to the Disk-on-Chip.
9. Load the secondary program loader files for the Disk-on-Chip. At the prompt
enter:
Config> WRITE SPL C:\temp\doc_spl.axf
After a short delay, a message displays indicating that the secondary loader has
been successfully programmed to the Disk-on-Chip.
10. Load the Boot Monitor as the boot program. At the prompt enter:
Config> WRITE BOOT C:\temp\boot_monitor.axf
After a short delay, a message displays indicating that the Boot Monitor has been
successfully programmed to the Disk-on-Chip.
11. Loading the images into the Disk-on-Chip NAND flash takes a few minutes to
complete. Wait until the prompt is displayed again before proceeding.
12. Verify that the boot file has been copied to the Disk-on-Chip boot region by
entering:
Config> LIST
13. Turn the board off and then on.