Filter
Top Products
MGC Manager User’s Guide - Volume I
4-39
Entry Queue
Access
Select this option to force participants to access the
conference via an Entry Queue. Once the participants are
connected to the Entry Queue, they enter the correct
conference Numeric ID or password (depending on the
MCU configuration) to join the conference.
When this option is selected:
• ISDN participants dial the EQ dial-in number
• H.323 participants dial the IP Network Service Prefix
and the Entry Queue Numeric ID
• SIP participants enter the Entry Queue URI
See “Defining Participant Properties” on page 4-101.
Meet Me Per Conf Select this option to enable the Meet Me Per Conference
conference. The Meet Me Per Conf tab appears.
Meet Me Per conference allows “undefined” participants to
connect to a conference by dialing a pre-defined dial-in
number. “Undefined” participants are not defined prior to
the conference start.
Note: If the Entry Queue Access conference is set as Meet
Me Per Conf, a separate dial-in number is assigned to the
conference, which participants can use to connect to the
conference directly (not via an Entry Queue). If you do not
require the direct dialing to the conference and to save
dial-in numbers, select either the Meet Me Per Conf option
or the Entry Queue Access option.
Table 4-4: Conference Properties - General (Continued)
Field/Option Description