Filter
Top Products
1046 | Broadcast Storm Control
www.dell.com | support.dell.com
Multicast Storm Control
Multicast Storm Control is supported only on platforms: c s
Storm Control Show Commands
The show storm-control commands display the current storm control configuration of the entire Dell
Force10 platform. These show commands are accessed from within either the EXEC or EXEC
Privilege
mode, and consist of the following three commands:
• show storm-control broadcast
• show storm-control multicast
• show storm-control unknown-unicast
These show commands can be entered with or without the interface option. Without the interface option,
storm control configuration information for the entire Dell Force10 platform is displayed.
To display the storm control configuration of a particular interface, use the interface option along with the
interface-type keyword and the slot and port information.
The following is a list of the interface-type keywords:
•
Fastethernet — for a fast Ethernet interface
•
GigabitEthernet — for a 1-Gigabit Ethernet interface
•
TenGigabitEthernet — for a 10-Gigabit Ethernet interface
The following example uses the
show storm-control broadcast command to display the storm control
configuration on a Gigabit Ethernet interface on port 11, in slot 11 of an E-
Series platform.
Task Command Syntax Command Mode
On the E-Series, suppress unknown-unicast packets if
they exceed a user-defined limit.
storm-control unknown-unicast
percentage partial-percentage
[in |
out]
CONFIGURATION
On the C-Series and S-Series, unknown-unicast packets
on ingress if they exceed a user-defined limit.
storm-control unknown-unicast
packets-per-second in
CONFIGURATION
Task Command Syntax Command Mode
Suppress multicast packets if they exceed a user-defined
limit.
storm-control multicast
packets-per-second in
CONFIGURATION