Filter
Top Products
Content Addressable Memory | 297
Figure 11-9. Configuring Ingress Layer 2 ACL on the Entire System
Return to the Default CAM Configuration
Return to the default CAM Profile, microcode, IPv4Flow, or Layer 2 ACL configuration using the
keyword
default from EXEC Privilege mode or from CONFIGURATION mode, as shown in Figure 11-10.
FTOS(conf)#do show cam-l2acl | find “Line card 1”
-- Line card 1 --
Current Settings(in percent)
Sysflow : 6
L2Acl : 14
Pvst : 50
Qos : 12
L2pt : 13
Frrp : 5
[output omitted]
FTOS(conf)#cam-l2acl system-flow 100 l2acl 0 p 0 q 0 l 0 f 0
FTOS(conf)#do show cam-l2acl | find “Line card 1”
-- Line card 1 --
Current Settings(in percent)
Sysflow : 6
L2Acl : 14
Pvst : 50
Qos : 12
L2pt : 13
Frrp : 5
[output omitted]
FTOS(conf)#do copy run start
File with same name already exist.
Proceed to copy the file [confirm yes/no]: yes
!
8676 bytes successfully copied
02:00:49: %RPM0-P:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by
default
FTOS(conf)#do show cam-l2acl | find “Line card 1”
-- Line card 1 --
Current Settings(in percent) Next Boot(in percent)
Sysflow : 6 100
L2Acl : 14 5
Pvst : 50 5
Qos : 12 5
L2pt : 13 5
Frrp : 5 5