Filter
Top Products
188 | Bidirectional Forwarding Detection
www.dell.com | support.dell.com
• The neighbor inherits only the global timer values that are configured with the bfd all-neighbors
command (interval, min_rx, and multiplier).
If you explicitly enable (or disable) a peer group for BFD that has no BFD parameters configured (e.g.
advertisement interval) using the
neighbor peer-group-name bfd command, the peer group inherits any
BFD settings configured with the
bfd all-neighbors command.
Displaying BFD for BGP Information
To display information about BFD for BGP sessions on a router, enter one of the following show
commands:
Task Command Command Mode
Verify a BFD for BGP configuration.
show running-config bgp
Figure 9-14
EXEC Privilege
Verify that a BFD for BGP session has been
successfully established with a BGP neighbor. A
line-by-line listing of established BFD
adjacencies is displayed.
show bfd neighbors [interface] [detail]
Figure 9-15 and Figure 9-16
EXEC Privilege
Display BFD packet counters for sessions with
BGP neighbors.
show bfd counters bgp [interface]
Figure 9-17
EXEC Privilege
Check to see if BFD is enabled for BGP
connections.
show ip bgp summary
Figure 9-18
EXEC Privilege
Displays routing information exchanged with
BGP neighbors, including BFD for BGP
sessions.
show ip bgp neighbors [ip-address]
Figure 9-19
EXEC Privilege