Filter
Top Products
IP Access Control Lists (ACL), Prefix Lists, and Route-maps | 159
Figure 8-19. Resequencing ACLs
Remarks and rules that originally have the same sequence number have the same sequence number after
the
resequence command is applied. Remarks that do not have a corresponding rule will be incremented as
as a rule. These two mechanisms allow remarks to retain their original position in the list.
For example, in Figure 8-20, remark 10 corresponds to rule 10 and as such they have the same number
before and after the command is entered. Remark 4 is incremented as a rule, and all rules have retained
their original positions.
FTOS(config-ext-nacl)# show config
!
ip access-list extended test
remark 4 XYZ
remark 5 this remark corresponds to permit any host 1.1.1.1
seq 5 permit ip any host 1.1.1.1
remark 9 ABC
remark 10 this remark corresponds to permit ip any host 1.1.1.2
seq 10 permit ip any host 1.1.1.2
seq 15 permit ip any host 1.1.1.3
seq 20 permit ip any host 1.1.1.4
FTOS# end
FTOS# resequence access-list ipv4 test 2 2
FTOS# show running-config acl
!
ip access-list extended test
remark 2 XYZ
remark 4 this remark corresponds to permit any host 1.1.1.1
seq 4 permit ip any host 1.1.1.1
remark 6 this remark has no corresponding rule
remark 8 this remark corresponds to permit ip any host 1.1.1.2
seq 8 permit ip any host 1.1.1.2
seq 10 permit ip any host 1.1.1.3
seq 12 permit ip any host 1.1.1.4