Dell S50V Switch User Manual


  Open as PDF
of 1262
 
556 | Link Aggregation Control Protocol
www.dell.com | support.dell.com
Figure 24-18. Using the show interface Command to Inspect a LAG Port on BRAVO
Shows
the
status
of
this
nterface.
Also shows it is part of LAG 10.
Shows the speed of this physical interface.
Also shows it is the Master of the GigE link.
Bravo#show int gig 3/21
GigabitEthernet 3/21 is up, line protocol is up
Port is part of Port-channel 10
Hardware is Force10Eth, address is 00:01:e8:09:c3:82
Current address is 00:01:e8:09:c3:82
Interface index is 140034106
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
Flowcontrol rx on tx on
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:15:05
Queueing strategy: fifo
Input Statistics:
708 packets, 89934 bytes
0 Vlans
0 64-byte pkts, 15 over 64-byte pkts, 693 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
708 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
705 packets, 89712 bytes, 0 underruns
0 64-byte pkts, 12 over 64-byte pkts, 693 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
705 Multicasts, 0 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Tim
e
s
in
ce
l
ast
in
te
rf
ace
status
c
h
a
n
ge:
00:
12
:39
Shows that this is a Layer 2 port.