Filter
Top Products
682 | Object Tracking
www.dell.com | support.dell.com
To configure object tracking on the status of a Layer 2 interface, use the following commands. To remove
object tracking on a Layer 2 interface, enter the
no track object-id command.
Figure 31-2. Command Example: track interface line-protocol
Tracking a Layer 3 Interface
You can create an object that tracks the routing status of an IPv4 or IPv6 Layer 3 interface. You can track
the routing status of any of the following Layer 3 interfaces:
• 1-Gigabit Ethernet: Enter
gigabitethernet slot/port in the track interface interface command (see Step 1
below).
• 10-Gigabit Ethernet: Enter
tengigabitethernet slot/port.
• Port channel: Enter
port-channel number, where valid port-channel numbers are:
• For the C-Series and S-Series, 1 to 128
• For the E-Series, 1 to 32 (EtherScale) and 1 to 255 (TeraScale and ExaScale)
• SONET: Enter
sonet slot/port.
• VLAN: Enter
vlan vlan-id, where valid VLAN IDs are from 1 to 4094.
Step Task Command Syntax Command Mode
1 Configure object tracking on the
line-protocol state of a Layer 2 interface.
track object-id interface interface
line-protocol
Valid object IDs are from 1 to 65535.
CONFIGURATION
2 (Optional) Configure the time delay used
before communicating a change in the
status of a tracked interface.
delay {[up seconds] [down
seconds]}
Valid delay times are from 0 to 180
seconds. Default: 0.
OBJECT TRACKING
3 (Optional) Identify the tracked object
with a text description.
description text
The text string can be up to 80
characters.
OBJECT TRACKING
4 (Optional) Display the tracking
configuration and the tracked object’s
status.
show track object-id
EXEC Privilege
FTOS(conf)#track 100 interface gigabitethernet 7/1 line-protocol
FTOS(conf-track-100)#delay up 20
FTOS(conf-track-100)#description San Jose data center
FTOS(conf-track-100)#end
FTOS#show track 100
Track 100
Interface GigabitEthernet 7/1 line-protocol
Description: San Jose data center
Line protocol is Up
2 changes, last change 00:03:05
Tracked by: