Filter
Top Products
422 | Interfaces
www.dell.com | support.dell.com
You can only configure one (1) primary IP address per interface. You can configure up to 255 secondary IP
addresses on a single interface.
To view all interfaces to see with an IP address assigned, use the
show ip interfaces brief command in the
EXEC mode (Figure 176).
To view IP information on an interface in Layer 3 mode, use the
show ip interface command in the EXEC
Privilege mode (Figure 159).
Figure 20-7. Command Example: show ip interface
ip address ip-address mask [secondary] INTERFACE Configure a primary IP address and mask on
the interface. The ip-address must be in
dotted-decimal format (A.B.C.D) and the
mask must be in slash format (/xx).
Add the keyword secondary if the IP
address is the interface’s backup IP address.
Command Syntax Command Mode Purpose
FTOS>show ip int vlan 58
Vlan 58 is up, line protocol is up
Internet address is 1.1.49.1/24
Broadcast address is 1.1.49.255
Address determined by config file
MTU is 1554 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent