Filter
Top Products
Force10 Service Agent | 359
To add a pre-defined list of conditions to your policy test list:
Table 16-2 shows the test conditions that are available to add to a custom policy test list. See the Dell
Force10 MIB for further description of the given Object Identifiers (OID). You may only specify one test
condition within a policy.
Hardware
Hardware Status
SFM status transition from active to another state
RPM status transition from active to another state
Line Card transition from active to another state
Port-pipe error or transition to down
PEM transition from up to another state
AC PSU transition from up to other state
Fan Tray down or individual fan down
Environmental status
Overtemp for each item listed in
show environment
Over/under-voltage for each item listed in show environment
Software SWP Timeout, IPC Timeout, IRC timeout, CPU > 85%, Memory usage > 85%
Task Command Command Mode
Add a pre-defined list of conditions to
your policy test list.
default-test [exception | hardware |
software
]
CALLHOME TESTLIST
Table 16-2. Custom Policy Test Conditions
Condition Keyword Description OID
CPU Usage
cpu-1-min
CPU utilization in percentage for the
last 1 minute.
chRpmCpuUtil1Min
cpu-5-min
CPU utilization in percentage for the
last 5 minutes.
chRpmCpuUtil5Min
Interface Rate/
Throttles
interface-bit-rate
Interface bandwidth in bits/second.
interface-rate
Interface bandwidth in packets/
second.
interface-throttles
The total number of valid ingress
frames with a length or type field
value equal to 0x8808 (Control
Frame).
f10IfInThrottles
f10IfOutThrottles
Interface
Errors
interface-crc
Frames received with a length
between 64 and 1518 octets,
inclusive, that had an incorrect CRC.
f10IfInCRC
Table 16-1. Pre-defined Policy Test Lists
Condition Conditions Tested