Dell S50V Switch User Manual


  Open as PDF
of 1262
 
58 | System Management
www.dell.com | support.dell.com
A user can access all commands at his privilege level and below.
Removing a command from EXEC mode
Remove a command from the list of available commands in EXEC mode for a specific privilege level
using the command
privilege exec from CONFIGURATION mode. In the command, specify a level greater
than the level given to a user or terminal line, followed by the first keyword of each command to be
restricted.
Move a command from EXEC Privilege mode to EXEC mode
Move a command from EXEC Privilege to EXEC mode for a privilege level using the command privilege
exec
from CONFIGURATION mode. In the command, specify the privilege level of the user or terminal
line, and specify all keywords in the command to which you want to allow access.
Allow Access to CONFIGURATION mode commands
Allow access to CONFIGURATION mode using the command privilege exec level level configure from
CONFIGURATION mode. A user that enters CONFIGURATION mode remains at his privilege level, and
has access to only two commands,
end and exit. You must individually specify each CONFIGURATION
mode command to which you want to allow access using the command
privilege configure level level. In the
command, specify the privilege level of the user or terminal line, and specify all keywords in the command
to which you want to allow access.
Allow Access to INTERFACE, LINE, ROUTE-MAP, and ROUTER mode
1. Similar to allowing access to CONFIGURATION mode, to allow access to INTERFACE, LINE,
ROUTE-MAP, and ROUTER modes, you must first allow access to the command that enters you into
the mode. For example, allow a user to enter INTERFACE mode using the command
privilege
configure level level interface
gigabitethernet
2. Then, individually identify the INTERFACE, LINE, ROUTE-MAP or ROUTER commands to which
you want to allow access using the command
privilege {interface | line | route-map | router} level level.
In the command, specify the privilege level of the user or terminal line, and specify all keywords in the
command to which you want to allow access.
The following table lists the configuration tasks you can use to customize a privilege level:
Task Command Syntax Command Mode
Remove a command from the list of available commands
in EXEC mode.
privilege exec level level
{command ||...|| command}
CONFIGURATION
Move a command from EXEC Privilege to EXEC mode. privilege exec level level
{command ||...|| command}
CONFIGURATION
Allow access to CONFIGURATION mode. privilege exec level level
configure
CONFIGURATION