1140 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
To track an interface or configured object for a virtual group, use the track command in the VRRP mode:
Figure 58-14. Command Example: track interface
Figure 58-15. Command Example: show configuration in VRID mode
Task Command Syntax Command Mode
Monitor an interface or a configured object and,
optionally, reconfigure the cost value to be
subtracted from the VRRP group priority if the
status of the tracked object goes DOWN.
track {interface | object-id}
[priority-cost cost]
Valid object IDs are from 1 to 65535.
Cost range: 1-254. Default: 10
INTERFACE-VRID
(Optional) Display the configuration and UP or
DOWN state of tracked objects, including the
client (VRRP group) that is tracking an object’s
state.
show track
EXEC
EXEC Privilege
(Optional) Display the configuration and UP or
DOWN state of tracked interfaces and objects in
VRRP groups, including the time since the last
change in an object’s state.
show vrrp
EXEC
EXEC Privilege
(Optional) Display the configuration of tracked
objects in VRRP groups on a specified interface.
show running-config interface
interface
EXEC
EXEC Privilege
Note: The sum of all the costs for all tracked interfaces and objects must be less than or equal to the
configured priority of the VRRP group.
FTOS(conf-if-gi-1/1)#vrrp-group 111
FTOS(conf-if-gi-1/1-vrid-111)#track gigabitethernet 1/2
FTOS(conf-if-gi-1/1-vrid-111)#
FTOS(conf-if-gi-1/1-vrid-111)#show configuration
!
vrrp-group 111
advertise-interval 10
authentication-type simple 7 387a7f2df5969da4
no preempt
priority 255
track GigabitEthernet 1/2
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
virtual-address 10.10.10.10
FTOS(conf-if-gi-1/1-vrid-111)#
