Filter
Top Products
290 | Content Addressable Memory
www.dell.com | support.dell.com
The ipv6acl and vman-dual-qos allocations must be entered as a factor of 2 (2, 4, 6, 8, 10). All other profile
allocations can use either even or odd numbered ranges.
You must save the new CAM settings to the startup-config (
write-mem or copy run start) then reload the
system for the new settings to take effect.
To configure the IPv4 and IPv6 ACLs and Qos regions on the entire system:
Test CAM Usage
The test cam-usage command is supported on platforms c e s
This command applies to both IPv4 and IPv6 CAM profiles, but is best used when verifying QoS
optimization for IPv6 ACLs.
Use this command to determine whether sufficient ACL CAM space is available to enable a service-policy.
Create a Class Map with all required ACL rules, then execute the
test cam-usage command in Privilege
mode to verify the actual CAM space required. Figure 11-3 gives a sample of the output shown when
executing the command. The status column indicates whether or not the policy can be enabled.
Figure 11-3. Command Example: test cam-usage (C-Series)
Step Task Command Syntax Command Mode
1
Select a cam-acl action
cam-acl [default | l2acl]
CONFIGURATION
Note: Selecting default resets the CAM entries to the default settings. Select l2acl to allocate space
for the ACLs, and QoS regions.
2 Enter the number of FP blocks for each
region.
l2acl number ipv4acl number ipv6acl
number, ipv4qos number l2qos
number, l2pt number ipmacacl
number ecfmacl number [vman-qos |
vman-dual-qos number
EXEC Privilege
3 Verify that the new settings will be written
to the CAM on the next boot.
show cam-acl
EXEC Privilege
4 Reload the system.
reload
EXEC Privilege
FTOS#test cam-usage service-policy input TestPolicy linecard all
Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status
------------------------------------------------------------------------------------------
2 | 1 | IPv4Flow | 232 | 0 | Allowed
2 | 1 | IPv6Flow | 0 | 0 | Allowed
4 | 0 | IPv4Flow | 232 | 0 | Allowed
4 | 0 | IPv6Flow | 0 | 0 | Allowed
FTOS#