Filter
Top Products
Troubleshooting
Troubleshooting the IDB
Chapter 12 593
• Upgrade of detail part running.
The detail upgrade was started and is currently running.
• Upgrade of detail part finished.
The detail upgrade finished.
The Cell Manager crashes during the core upgrade
The following methods can help you to identify the problem:
•The omnidbutil –upgrade_info command on the Cell Manager
reports Core upgrade failed.
•The upgrade.log file on the Cell Manager contains the UCP session
started entry but does not contain either the UCP session
finished nor the Session was aborted (Upgrade core part)
entry.
Action 1. Run /opt/omni/sbin/omnisv -status to check whether the Data
Protector services are running on the Cell Manager. If they are not
running, start them using the /opt/omni/sbin/omnisv - start
command.
2. Run the omnidbinit command on the Cell Manager to initialize the
new database. The A.03.51 IDB is set to read-only mode and is
therefore left intact.
3. Run the omnidbupgrade -ucp command to restart the core upgrade.
4. When the core upgrade is finished, continue with the detail part
upgrade.
The core upgrade runs out of disk space
The upgrade.log file on the Cell Manager contains the Not enough
disk space or not enough configure extension/binary files to
perform upgrade entry after the UCP session started entry. Refer to
the HP OpenView Storage Data Protector Software Release Notes for disk
space requirements.
Action 1. Free up disk space on the system where the IDB is installed.
2. Run the omnidbinit command to initialize the new database. The
A.03.51 IDB is set to read-only mode and is therefore left intact.
3. Restart the core upgrade using the omnidbupgrade –ucp command.