Filter
Top Products
Integrations with Other Applications
ManageX Integration
Chapter 13648
ManageX Integration
What Is the
ManageX
Integration?
ManageX integration is supported on those Windows systems where
ManageX is running. It allows the operator using ManageX to check
Data Protector operation and backup status.
What Is
Supported?
The integration supports the following:
• Sends the Data Protector messages with the severity levels you
choose to the ManageX console.
• Checks if all Data Protector services are running and sends a
messages to the ManageX console if one of the services stops.
Configuring the
Integration
To configure the ManageX integration with Data Protector perform the
following steps:
1. Enable Data Protector message forwarding on the Cell Manager:
a. In the global file set EventLogMessages=1. Refer to “Global
Options File” on page 523 for more information.
b. Stop and restart the Data Protector services.
2. To set the Data Protector severity levels you want to receive in the
ManageX console, delete or add them in the
<Data_Protector_home>\config\managex\filter file. By
default, all severity levels (normal | warning | minor | major |
critical) are listed in this file.
3. Distribute the policies from the ManageX to Data Protector Cell
Manager using the ManageX console. The Data Protector policies are
in the folder Backup Applications.