Filter
Top Products
ADIC/GRAU DAS and STK ACS Libraries
The STK ACS Library Device
Chapter 14686
/<Data_Protector_home>/acs/ssi/ssi.sh start
<ACS_LS_hostname>
4. On UNIX ACS client, run the following command to check whether or
not the library drives are properly connected to your system:
/opt/omni/lbin/devbra -dev
You should see the library drives with corresponding device
files/SCSI addresses displayed in the list.
Using Data Protector to Configure the STK ACS
Library
The direct library access configuration is the same as the ADIC/GRAU
DAS library direct access configuration. Follow the GUI steps provided
in the section “Using Data Protector to Configure the ADIC/GRAU
Library and Drives” on page 671. Instead of choosing GRAU DAS Library
as your device type, choose Storage Tek ACS Library.
Using Data Protector to Configure Drives
To configure drives in the STK ACS library, follow the same steps
provided in the ADIC/GRAU DAS section “Using Data Protector to
Configure Drives” on page 670.
Indirect Access to the Library: Installation and
Configuration
This section focuses on the indirect access configuration.
Using Data Protector to Configure the STK ACS Library and
Drives
The indirect access configuration steps are the same as the direct access
configuration (see previous section for steps), except the default setting,
Force Direct Library Access, should be turned off.
• Follow the same GUI steps as for the direct library access
configuration. When the library configuration is complete, you will be
prompted to create library drives.